The following table lists recommendations for additional line-side components such as fuses.

Note for use in compliance with IEC standards:

3NA3 fuses are recommended for European countries. The values in the table take into account the overload capability of the inverter.

Note for use in compliance with UL regulations:

Fuses for use in North America must be UL-certified, Class J or Class CC fuses with a rated voltage of 600 V AC.

Short Circuit Current Rating (SCCR)
according to UL

Applies to industrial control panel installations according to NEC Article 409 or UL 508A.

• PM240M: 40 kA

Additional information about the listed fuses is available in the Catalogs LV 10, IC 10 and IC 10 AO as well as in the Industry Mall.

Individual protection

The SINAMICS G110M system supports an inverter loop-through of line current to several inverters connected in series.

Further information can be found in the operating instructions on the Internet at
http://www.siemens.com/sinamics-g110m/documentation

Group protection (installation on power bus)

For installations with several inverters, the inverters are normally supplied from a 400 V power bus.

Further information can be found in the operating instructions on the Internet at
http://www.siemens.com/sinamics-g110m/documentation