The flexible IWLAN RCoax/antenna connecting cables are required for connecting RCoax segments or antennas with active devices.
The cables offer low attenuation so that the quality of the radio signal is only minimally affected.
All antenna cables are flame-resistant, chemical-resistant and silicone-free.
These cables are also suitable for railway applications and meet the increased requirements for environmental conditions and fire protection which are required for use in vehicles (including EN45545-2).
Terminating resistors
Terminating resistors are required for wireless termination of unused antenna connections at the access points and clients.
RCoax segments must be terminated at the end with a terminating resistor.
Lightning protection elements
When separate antennas are used outdoors, there is a risk of lightning strikes.
A lightning protector can be used to prevent damage.
Cabinet feedthroughs
Together with the antenna connecting cables, the cabinet feedthroughs enable simple connection of remote antennas to the active components located in the control cabinet/box.
Attenuator
The 10 dB attenuator is always used when the transmitted power has to be reduced both in the send and receive directions. Typical application areas include short RCoax segments or directional wireless links which are to be limited in extent.
Power splitters
With the help of the power splitter, the transmission power of an access point is divided between two RCoax or antenna segments.
This enables wireless coverage in two areas using just one access point.
Product versions
RCoax/antenna connecting cables
Pre-assembled cable lengths (0.3 m, 1 m, 2 m, 5 m and 10 m)
Different connector types and combinations (N-Connect, R-SMA, SMA, QMA)
Two different cable versions: Standard cables and cables suitable for railway applications
Terminating resistors
TI795-1R: Terminating resistor 50 ohms for R-SMA antenna sockets
TI795-1N: Terminating resistor 50 ohms for N-Connect antenna sockets or RCoax segments
Lightning protection elements
LP798-2N: Maintenance-free lightning protection element for N-Connect connections
Quarter-wave system (lambda-quarter) for the frequency range 2 to 6 GHz
Represents a short-circuit for DC voltages so that all types of overvoltage can be reliably diverted
Not suitable for DC infeed via the antenna cable
LP798-1N: Lightning protection element for N-Connect connections
With gas discharge arrester for the frequency range 0 to 6 GHz for N-Connect connections
Suitable for DC infeed via the antenna cable
Cabinet feedthroughs
N-Connect female/SMA female with fastening flange for panel thicknesses up to 5.5 mm
N-Connect female/N-Connect female without flange for panel thicknesses up to 4.5 mm
Can also be used to connect two antenna connecting cables
