6AT8002-4AB00Öåíà íà ñàéòå óêàçàíà ðîçíè÷íàÿ â ÅÂÐÎ áåç ó÷åòà ÍÄÑ.
 SIMOCODE connecting cables SIMOCODE connecting cable 3UF7930‑0AA00‑0 The connecting cable is used for connecting the SIPLUS CMS2000 Basic Unit VIB to the SIPLUS CMS2000 VIB‑MUX expansion modules and the temperature modules via the SIMOCODE system bus interface. The connecting cable with a length of 0.025 m must be used for side-by-side mounting of the basic unit and SIPLUS CMS2000 VIB‑MUX expansion modules or temperature modules on a TH 35‑15 standard DIN rail in accordance with IEC 60715. Shield connection 6AT8002-4AA00 shield connection A separate shield connection must be ordered for the EMC-compliant connection of signal and encoder cables to the SIPLUS CMS2000 Basic Unit VIB and the SIPLUS CMS2000 VIB‑MUX expansion module. The shield connection comprises two shield clampsand five terminal clamps. One shield clamp each is attached to the DIN rail above and below the basic unit. The sensor cable shields are connected to the shield clamps by means of the terminal clamps. VIB-SENSOR S01 vibration sensor VIB‑SENSOR S01 vibration sensor 6AT8002‑4AB00 The VIB‑SENSOR S01 vibration sensor with IEPE (integrated electronics piezo-electric) interface can be directly connected to the SIPLUS CMS2000 Basic Unit VIB and the SIPLUS CMS2000 VIB‑MUX expansion module. The sensor detects vibration accelerations in the frequency range from 0.5 Hz to 15 kHz with a resolution of 100 mV/g. A threaded screw with an M8 male thread for mounting to the measuring point is included in the scope of delivery. The connecting cable is connected to the vibration sensor via the MIL connector. SIPLUS CABLE-MIL connecting cables SIPLUS CABLE-MIL connecting cables 6AT8002‑4AC03, 6AT8002‑4AC10 The VIB‑SENSOR S01 vibration sensor is connected to the SIPLUS CMS2000 Basic Unit VIB or the SIPLUS CMS2000 VIB‑MUX expansion module by means of the SIPLUS CABLE-MIL connecting cable. This high-quality industrial cable is made of black polyurethane and is pre-assembled on one end with a MIL connector (MIL-C5015). The open cable end of the shielded two-wire cable is connected directly to the screw terminals of the basic unit. The connecting cable is available in lengths of 3 m and 10 m. |
| Êàòàëîã 2018 | Êàòàëîã 2017 | Êàòàëîã 2016 | Êàòàëîã 2015 | Êàòàëîã 2014 | Êàòàëîã 2013 | Êàòàëîã 2012 | Ñåðòèôèêàò | Êîíòàêòû | Êàðòà ñàéòà | Ïîèñê |